What it costs: Priced by how many zones and valves are involved and whether it is a valve rebuild or a line break. We locate the fault first so the quote covers the actual problem.
Signs you need irrigation repair
- A water bill that jumped during landscape-watering months with no schedule change
- A zone that won't shut off, won't come on, or weeps after the cycle ends
- Wet, soggy, or eroding spots in the yard between emitters or heads
- Dry, dying plants on a drip line while the controller says the zone ran
- Mineral buildup, leaks, or a failed test on the irrigation backflow assembly
How we handle it
Diagnose the Zone
We test the controller, valves, and lines zone by zone to separate a controller or wiring issue from a real plumbing leak, so you only pay to fix what's actually broken.
Repair Lines & Valves
We replace failed diaphragm or solenoid valves, splice or re-run cracked poly and PVC lateral lines, and rebuild or replace drip manifolds and emitters that have clogged with hard-water scale.
Backflow & Pressure Check
We test and service the irrigation backflow preventer, set the system pressure so emitters and heads run correctly, and confirm every zone starts, runs, and shuts off clean.
What to know about irrigation repair in Arizona
Desert irrigation lives a hard life. Buried poly and PVC lateral lines sit in caliche and rocky fill that abrades and stresses them, while any tubing or fitting exposed at the surface bakes under intense UV that makes plastic brittle within a few seasons. Drip emitters, the efficient choice for xeriscape and native desert plantings, are also the first thing to clog, because Arizona's 16-to-20-grain hard water deposits scale inside the tiny orifices. When a homeowner says half their plants are dying even though the controller runs, the cause is usually clogged emitters or a cracked sub-surface line, not the plants and not the timer.
The irrigation valve is where most repair calls actually land. Each zone is controlled by an electric valve with a rubber diaphragm and a solenoid, and both wear out. A diaphragm that's torn or fouled with grit lets a zone weep or run forever. A failed solenoid means the zone won't open at all. Hard-water sediment and the fine silt in desert soil speed up this wear. We can usually rebuild a quality valve with new internals, but bargain valves are often cheaper to replace outright. Either way we test the wiring and controller first, because a dead zone is sometimes a solenoid and sometimes just a broken wire.
The backflow preventer is the safety device most homeowners forget about until it leaks or fails a test. Because irrigation water mingles with fertilizer, soil bacteria, and standing water in the lines, code requires a backflow assembly to stop that water from getting siphoned back into the potable supply during a pressure drop. Arizona freeze events in the high country and the occasional Valley cold snap crack these brass assemblies if they aren't drained or insulated for winter. We test backflow devices to certified standards, rebuild the internal checks, and replace assemblies that are cracked or beyond repair.
Irrigation Repair across Arizona
We provide irrigation repair throughout the Phoenix metro and Northern Arizona high country:
